Муқаддима
This manual provides comprehensive instructions for the installation, operation, and maintenance of the Hunter 99179 Original Ceiling Fan Remote Control and Canopy Kit. This kit is specifically designed to enhance the functionality of Hunter "Original" series ceiling fans by adding remote control capabilities for fan speeds and lighting.
The kit includes a remote control unit and a canopy designed to house the receiver. It integrates with your existing two-wire fan setup, offering convenient control over three fan speeds and the fan's light fixture.
Маълумоти муҳим оид ба бехатарӣ
- Бехатарии барқ: Always disconnect power at the circuit breaker or fuse box before attempting any installation, maintenance, or repair. Failure to do so can result in serious injury or death.
- Мутобиқат: This kit is designed for use ТАНХО with Hunter "Original" series ceiling fans. It is not compatible with other fan models or brands.
- Downrod Requirement: Installation requires a downrod of 12 inches or longer (sold separately). The receiver unit is designed to fit within the canopy, which necessitates sufficient space provided by a longer downrod.
- Насби касбӣ: If you are unfamiliar with electrical wiring or ceiling fan installation, it is recommended to consult a qualified electrician.
- Рамзҳои маҳаллӣ: Ensure all installation procedures comply with local electrical codes and ordinances.
- якпорчагии маҳсулот: Do not modify the product or use it for purposes other than its intended use.
Мундариҷаи баста
Пеш аз оғози насбкунӣ тасдиқ кунед, ки ҳама ҷузъҳо мавҷуданд:
- Воҳиди идоракунии дурдаст
- Қабулкунандаи дурдаст
- Canopy (for receiver housing)
- Mounting Hardware (screws, wire nuts, etc. - specific items may vary)

Image: A Hunter ceiling fan, representative of the type of fan compatible with the 99179 remote and canopy kit.
Насб ва насб
Follow these steps carefully to install your Hunter 99179 Remote Control and Canopy Kit:
- Қатъи барқ: Before starting, turn off the electrical power to your ceiling fan at the main circuit breaker or fuse box.
- Ноқилҳои дастрасӣ: Carefully lower the existing canopy from your Hunter Original ceiling fan to expose the wiring connections.
- Remove Old Receiver (if applicable): If an old receiver is present, disconnect its wiring and remove it.
- Install New Receiver: Connect the new remote receiver's wires to the corresponding fan and household wires. Ensure all connections are secure using wire nuts. The receiver is designed to fit within the new canopy.
- Пойгоҳи мавқеъ: Carefully tuck the wired receiver into the new canopy. Ensure no wires are pinched.
- Пойгоҳи бехатар: Mount the new canopy securely to the fan's mounting bracket. Confirm that the downrod is at least 12 inches long to accommodate the receiver within the canopy.
- Барқарор кардани қудрат: Once installation is complete and all connections are secure, restore power to the ceiling fan at the circuit breaker.
- Ҷуфти дурдаст: Follow the instructions provided with the remote control unit to pair it with the newly installed receiver. This typically involves pressing a button on the remote within a short time after restoring power.
Шарҳ: The new canopy is designed to accommodate the receiver. Some older Hunter Original fan mounting plates or downrods may not be compatible with the new canopy's dimensions. Verify fit before final installation.
Дастурҳои амалиётӣ
Your Hunter 99179 remote control provides convenient operation of your ceiling fan and light:
- Назорати суръати мухлиси: Use the designated buttons on the remote to cycle through three fan speeds (Low, Medium, High) or to turn the fan off.
- Назорати нур: Use the light button to turn the fan light on or off. Some remotes may also support dimming functions if your fan and light kit are compatible.
- Иваз кардани батарея: If the remote control stops responding, replace the batteries. Refer to the remote's specific instructions for battery type and replacement procedure.
Нигоҳдорӣ
To ensure optimal performance and longevity of your Hunter 99179 kit:
- Тозакунӣ: Periodically wipe the remote control and canopy with a soft, dry cloth. Do not use abrasive cleaners or solvents.
- Санҷиши батарея: Replace remote control batteries as needed to maintain reliable operation.
- Санҷиши ноқилҳо: Annually, or if issues arise, ensure all electrical connections within the canopy are secure and free from corrosion. Always disconnect power before inspection.
Мушкилкушо
If you encounter issues with your remote control and canopy kit, refer to the following common solutions:
| Мушкилот | Сабаби эҳтимолӣ | Ҳалли |
|---|---|---|
| Remote not responding / Fan or light not working |
|
|
| Canopy does not fit / Receiver cannot be housed |
|
|
| Дахолати дигар дастгоҳҳо |
|
|
Мушаххасоти
- Рақами модел: 99179
- Истеҳсолкунанда: Ширкати Хантер Фан
- Андозаҳои маҳсулот: Тақрибан 6 x 6 x 7 дюйм
- Вазни ашё: Тақрибан 2.35 фунт
- Ҷилдиtage: 120 вольт
- Манбаи нерӯ: Сими барқӣ
- Мавод: Металл
- Сертификатсия: ETL номбар шудааст
- Истифода: Ceiling fan remote control and canopy accessory
- Хусусияти махсус: Сохтмони вазнин
- Дастгоҳҳои мувофиқ: Hunter "Original" series ceiling fans
Маълумот дар бораи кафолат
No specific warranty description is provided for the Hunter 99179 Remote Control and Canopy Kit in the product details. For warranty inquiries, please contact Hunter Fan Company directly or refer to the documentation included with your original Hunter "Original" ceiling fan.
Дастгирии муштариён
For further assistance, technical support, or to inquire about parts, please visit the official Hunter Fan Company webсайт ё шӯъбаи хидматрасонии муштариёни онҳо тамос гиред.
Ширкати Хантер Фан Webсайт: Visit the Hunter Store on Amazon





